Fagor Eco Concept CCO-120, Service Manual

Page: 10 / 79

02/05/2020 9
SERVICE MANUAL
CONVEYOR BELT
DISHWASHERS
-
Remove hard deposits by applying water and soap or neutral detergents, and using a plastic or wooden
spatula if necessary.
-
Clean the inside of the chamber to prevent the build-up of dirt with neutral chlorine-free non-abrasive
detergents.
-
The zones around the appliance should also be cleaned everyday with soap and water, avoiding chlorine-
based or toxic detergents. Rinse with clean water and dry thoroughly.
7.4. SPECIALISED MAINTENANCE
To ensure that the equipment is in perfect and safe condition, it should be maintained and serviced by an Authorised
Service Centre at least once a year.
DANGER
•
High voltage.
•
Before removing the panel from the machine, accessing components and carrying out work on live
components, disconnect the machine from the power supply.
Use the resources and tools suited to each operation on the machine.
Call the technical service twice a year to have the machine serviced:
• Cleaning of water filter.
• Cleaning of lime on the resistors, pipes and surfaces of the equipment. The use of phosphoric-based
products is recommended.
•
Inspection of the condition of the seals.
•
Inspection of the condition of the parts.
•
Checking the correct operation of the dispensers.
• Tightening of the electrical connections on the terminals, once a year.

Check that the temperature of the premises does not exceed that indicated for your machine.

The guarantee will be made void if there is insufficient ventilation.
 Check that the doors close properly.

Do not disassemble the mobile components guards or front panels without first having turned the appliance
off.
 Gloves must be worn before accessing the appliance area, given the existence of high temperatures of some
components, with the resulting risk of burns.

If the supply hose is damaged, it should be replaced by authorised technical personnel in order to avoid
risks.

It if is replaced, the earth pin must be positioned again.

If a cable requires replacement, the cross-section must never be reduced.

If it is necessary to disassemble the inner lid of the electrical installation, it is extremely important to leave it
exactly as it was when reassembling it.