Fagor CO-500, Service Manual, Page: 22 / 124

22/07/2019
21
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
8.4.1. RINSE AID HYDRAULIC DISPENSER CONNECTION (CONCEPT)
INSTALLATION
The water rinse aid dispenser is pre-installed in the appliance. First, the end of the blue tube with filter located at
the back of your machine and marked “Rinse Aid” must be inserted inside the rinse container.
The tubes are see-through to allow you to check that the chemicals are correctly dispensed.
To access the dispensers and adjust them, remove the lower front cover of the appliance.
OPERATION
To operate, this dispenser uses the rinse pressure of the dishwasher, and therefore does not need an electrical
connection. In each rinse cycle, it dispenses between 0 and 4.5 cm 3 of rinse aid according to the adjustment made.
LOADING PROCESS
The dispenser has a button on the front for the initial loading of the dispenser, on the adjustment screw itself.
Press the adjustment screw several times until the system is fully loaded.
ADJUSTING THE DOSE
The dispenser should be adjusted when the machine is installed to ensure that the wash is optimised from the
start. The setting should be adjusted according to the type of rinse aid and the water hardness. Turn the
adjustment screw until the required dose is obtained (turn clockwise to reduce and anticlockwise to increase the
dose).
A quantity of rinse aid is injected into each rinse cycle. This quantity can be adjusted between 0 and 4.5 cm 3 ,
equivalent to the movement of rinse aid in the intake tube of between 0 and 40 cm in length.
For each turn of the screw, the dose changes by approximately 4.4 cm of the length of the intake tube (0.5
cm 3 /turn).
Adjustment and
loading
(Adjustment
screw /
Load
button)
Rinse
line
Rinse Aid
Filter