Fagor CO-500, Service Manual

Page: 61 / 124

22/07/2019
60
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
THIS APPLIANCE MAY ONLY BE REPAIRED BY AN AUTHORISED AND QUALIFIED TECHNICAL
SUPPORT SERVICE.
THE MANUFACTURER MAY NOT BE HELD LIABLE FOR ANY PROPERTY DAMAGE OR
PERSONAL INJURY RESULTING FROM THE INCORRECT INSTALLATION, USE, MAINTENANCE
OR REPAIR, OR CAUSED BY FAILURE TO COMPLY WITH THE STANDARDS AND
INSTRUCTIONS PROVIDED.
FAULT POSSIBLE CAUSE ACTION
The machine
does not come
on
The appliance does not receive
mains power.
Check whether the magneto-thermal circuit
breaker or the differential switch has tripped.
Blown fuses. Change fuses
Water does not
enter the
machine.
Interruption to the supply of water
or the intake water valve is closed.
Check whether there is water in the main
system and open the shut-off valve.
Rinse nozzles blocked.
Clean the nozzles. If there is a build-up of lime
on the arm, contact the technical service to
have the appliance cleaned.
Solenoid valve filter blocked. Clean solenoid valve filter
Faulty solenoid valve. Replace solenoid valve
Rinse pump faulty Replace pump
Pressostat is broken. Replace pressure switch
Incorrect wash.
There is no detergent. Fill recipient.
Insufficient detergent. Contact chemicals supplier.
Wash distributors obstructed. Clean distributors thoroughly.
Dirty filters. Clean the filters thoroughly.
Presence of foam.
Inadequate detergent. Change detergent.
Too much rinse aid. Call the technical service
to reset the dispenser.
Temperature in tank less than 50
ºC / 122 ºF.
Faulty thermostat or incorrect setting. Contact
your Technical Assistance Service.
Cycle length too short.
Select a longer cycle in accordance with the
dirt on the dishes.
Water too dirty. Drain the wash tub and fill with clean water.
Dishes and
kitchenware are
not dry
There is no rinse aid Fill the rinse aid container.
Insufficient rinse aid. Contact chemicals supplier.
Dishes left inside dishwasher for
too long.
Remove the dishes at the end of the wash
cycle and leave to dry by evaporation for a
minute.
Rinse temperature lower than 80
⁰
C / 176
⁰
F.
Allow the boiler to reach the rinse temperature
before starting the cycle. If the problem
persists, call the technical service.
Dishes stained
or scratched.
Too much rinse aid. Contact chemicals supplier.
High water hardness.
Check the water hardness, it should be less
than 10 ºfH.
SOFT models: Not enough salt in
salt deposit or incorrect
regeneration.
Top up salt container.
If necessary, contact the technical service for
the adjustment of the water hardness setting.
Traces of salt in tub.
When filling the salt deposit, take care not to
spill salt in the tub and clean thoroughly.