9
8
8
9
10
10
17
19 20
16
English
12 EN
17. Programming the coffee measures
“Before programming the coffee dispensing
push buttons
¿
ll the
¿
lter holder with the correct
serving of ground coffee. Don’t use coffee grouts
for programming servings.”
Fit and tighten the
¿
lter holder (
10
) on the coffee dispenser
unit, positioning the cup (or cups) under the nozzle (or
nozzles) of the
¿
lter holder (
10
).
Press (and keep momentarily pressed) the coffee
dispensing push button (
16, 17, 19
or
20
) corresponding
to the required serving to be programmed.
When the amount of coffee in the cup reaches the required
level, release the coffee dispensing push button.
Repeat the above operations for the other coffee push
buttons.
Note: if you make a programming mistake, use a new dose
of ground coffee and repeat the operation.
18. Programming the hot water measures
After positioning the correct container under the hot water
nozzle (
8
), raise the hot water dispensing lever (
9
) to
release water.
Once the amount of water reaches the desired level,
release the lever (
9
): this sets the programmed dose.
1 DISPENSER UNIT MACHINES
To perform the programming of the water dose follow the
procedure here below:
1) Place a container by the hot water distribution nozzle
(
8
).
2) Keep the distributor key (
9
).
3) When the quantity of water in the container has reached
the desired level, press again the key (
9
).
1 Dispenser unit machines
