5
LIMIT SWITCH FITTING INSTRUCTIONS
Fix the limit switch striking plates as shown in the diagram: the
distance between the roller tip of the limit switch spring and the
striking plate front surface line must be 15 mm.
This distance will allow the correct operation of the limit switch
spring in both travelling directions (pic. 5). Should the limit switch
roller go beyond the 15 mm distance, unscrew and remove the
roller, then cut the spring to measure.
IMPORTANT:
the gate must stop before hitting the
gate post or special gate stops to prevent any
damage to its structure.
JUNCTION BOX/PIT
WHERE ALL CABLES ARE
PRE-TERMINATED
WIRING DIAGRAM AND ACCESSORIES
Before fitting Mec 200 make sure the installation is pre-set for all the safety and control accessories as required (Pic. 6).
The safety edges, mechanically wire-operated and resistive 8,2 kΩ, fixed on the gate's leaf may be connected by cable, by mean of
the safety radio device Arpo 58 or with the photocells Orbita 57.
General layout: it is the installer’s responsibility to lay the connection pipes and tubes as properly and correctly required.
IMPORTANT:
all the electrical equipment to be properly earthed.
English
MEC 200
Pic. 5
Pic. 6
!
!
15 mm
LIMIT SWITCH STRIKING
PLATE TO BE FIXED
TO THE GATE BY BOLTS
LIMIT SWITCH ROLLER
FA
DI
NI
1
2
9
8
3
11
4
5
17
6
7
10
12
13
13
14
15
16
230 V
n°2x1
n°2x1
n°4x1
n°4x1
cable R
G58
n°4x1,5
n°4x1,5
n°4x1
n°2x1
n°3x1
1 - Miri 4 Flashing lamp - code 4612L
2 - Fit 55 recess photocell transmitter - code 551L
3 - Arpo 58 receiver - code 5801L
4 - Elpro 37 controller - code 7087L
5 - 230 V - 50 Hz - 0,03 A magneto-thermal
differential circuit breaker (not supplied with the equipment)
(2,5 mm² cable section beyond 100 m)
6 - Mec 200 gate operator
7 - Gear rack code 204L
8 - Arpo 58 transmitter - code 5802L
9 - Mechanical cable-operated edge - code 2077L
10 - Chis 37 recess key-switch - code 371L
11 - Vix 53/2 R plug-in radio receiver - code 5311L
12 - Birio A8 aerial - code 4605L
13 - Fit 55 recess photocell receiver - code 551L
14 - 0,5 m post - code 555L
15 - Post fixing plate with cover - code 554L
16 - VIX 53/4 TR transmitter - code 5313GL
17 - Gate stop
(compulsory, not supplied with the equipment)
2
14
15
17
electro-mechanical sliding gate operator
