3
INSTRUCTIONS TO FIT THE VERTICAL AND HORIZONTAL MEC 200 OPERATORS TO A SLIDING GATE
FOR A PROPER AND PERFECT PERFORMANCE OF MEC 200 READ THE INSTRUCTIONS THAT ARE OUTLINED IN THIS MANUAL AND
KEEP TO THE DIAGRAMS.
Mec 200 is an extremely versatile system and can suit any sliding gate as it can be mounted either vertically or horizontally, and the
motor is available in different power specifications such as 0,37 kW (0,5 HP single- and three-phase); 0,73 kW (1,0 HP single- and
three-phase); 1,1 kW (1,5 HP three-phase only). It is a strong and reliable automation. It has a torque control device that can be
manually adjusted; worm and gear are made of bronze and steel and are supported by bearings, in an oil bath. A manual overriding
system allows manual operations of the gate in emergency events like power failure.
POINTS TO CHECK WITH THE GATE
Check that the gate track is well fixed to a solid foundation to prevent deformation which would result into an unbalanced travelling
of the gate.
IMPORTANT:
• make sure that gate stops are fixed in the open and closed gate positions so that the gate does not over travel the
permitted limit and go out of the upper guide;
• make sure that a system be mounted to the gate to prevent it from falling over
;
• make sure that, once at the end of the permitted travel, the gate does not hit the gate posts or special gate
stops to avoid damages to its structure.
FITTING MEC 200 ON TO THE FIXING BASE PLATE
The first operation is to fix the fixing base plate to the ground and make sure that it is perfectly levelled. Fixing distances are as
indicated in pic. 1 here below. Fixing is by setting the plate into a concrete foundation.
Remove the Mec 200 cover by loosening the three screws and pulling it upwards; temporary fix the Mec 200 operator to the fixing
base plate by means of the four screws (pic. 2).
English
MEC 200
Pic. 2
Pic. 1
80
GROUND
GROUND
PROTECTION
COVER
PROTECTION
COVER
SCREWS TO FIX
THE COVER
MEC 200 HORIZONTAL
MEC 200 HORIZONTAL
MEC 200 VERTICAL
FIXING BASE PLATE
TO SET IN CONCRETE
SPIRIT LEVEL
120
90
80
GROUND
MEC 200 VERTICAL
FIXING BASE PLATE
TO SET IN CONCRETE
SCREWS TO FIX
THE COVER
No. 4
FIXING SCREWS
No. 4
FIXING SCREWS
80
80
120
90
!
electro-mechanical sliding gate operator
