31. Locate the Alignment cam kit (FT292). Locate the
factory control arms. Install the lower control arms into
the Fabtech crossmembers using the hardware in the
cam kit (FT292). Torque the cam bolts at 200 ft-lbs after
alignment. Torque crossmember bolts to 240 ft-lbs.
SEE
FIGURE 32
32. If installing Dirt Logic coilovers (FTS22183 or
FTS22185) do so at this time, using the instructions
provided in the shock box. Once fi nished, you may
skip to STEP 38.
If using FTS30503 coilover continue to STEP 33.
33. Locate the factory coilovers removed earlier.
34. Using a spring compressor, compress the factory spring
and remove the top coilover center nut and cap. Next
install the factory spring onto the new Fabtech coilover
using the new lower isolator and re-using the factory top
cap and hardware.
SEE FIGURE 33
35. Repeat Step 34 on the passenger side.
36. Install the coil over into the frame bucket using the factory
hardware. Torque 59 ft-lbs.
SEE FIGURE 34-35
37. Rotate the lower control arm up and mount to the lower
coilover bar pin using the supplied 1/2”-13 X 3” bolts and
hardware. Torque to 127 ft-lbs.
SEE FIGURE 36
10 of 17
FIGURE 32 - STEP 31
FIGURE 34 - STEP 36
FIGURE 35 - STEP 36
FIGURE 36 - STEP 37
FIGURE 33 - STEP 34
