42. Install the wheel speed sensor. Make sure the end of the
sensor is clean. Torque to 21 ft-lbs
SEE FIGURE 43
43. Install the dust shield and torque to 14 ft-lbs. Install CV
shaft nut and torque to 35 ft-lbs. Install the factory dust
cover.
SEE FIGURE 44
44. Reconnect the vacuum line to the hub assembly. Using
the factory bolt Install the Fabtech brake line bracket
(FT30496) to the frame. Use the supplied 5/16”-18 X 1”
bolts and hardware to connect the brake line to the new
Fabtech bracket. Using the factory hardware, mount
factory brake line bracket to the side of the Fabtech
knuckle. After installing the factory brake line bracket,
check to insure full movement by steering the knuckle
back and forth, and make sure none of the ABS lines,
brake lines, or vacuum lines are inhibited during full test
movement of the knuckle.
SEE FIGURES 45-46
45. Reinstall the original brake rotor, followed by the brake
caliper. Use a small amount of the supplied thread lock
compound on the caliper bolts and torque to 145 ft-lbs.
SEE FIGURE 47
12 of 17
FIGURE 43 - STEP 42
FIGURE 44 - STEP 43
FIGURE 45 - STEP 44
FIGURE 46 - STEP 44
FIGURE 47 - STEP 45
