9. Locate the lower shock mount bar pin nuts and remove.
Loosen and remove the control arm at the crossmembers
and save for re-installation.
SEE FIGURES 7-8
10. Locate the three upper coilover nuts and remove. Save
the hardware. Remove the shock assembly from the
vehicle and mark “Driver” for assembly to install later with
Fabtech shock extensions.
NOTE: If installing Dirt Logic
coilovers the factory coilover and hardware will not be
re-used. SEE FIGURE 9
11. Repeat steps 4 through 10 on the passenger side of the
truck.
12. Remove the factory rear crossmember from the vehicle
and discard.
NOTE: Due to varinces in vehicles, the
bolt attaching the crossmember and the frame on the
drivers side may need to be cut off.
SEE FIGURE 10-11
5 of 17
FIGURE 5 - STEP 8
FIGURE 6 - STEP 8
FIGURE 7 - STEP 9
FIGURE 8 - STEP 9
FIGURE 9 - STEP 10
FIGURE 10 - STEP 12