27
UK/IRL
26
UK/IRL
6. COMMISSIONING
(functional checks)
6.1. Check pilot ignition
1.
Push in and turn the control knob (A) from
{
anticlockwise to
the setting
(small flame). You will hear a tick meaning there is
ignition. Hold the knob in and wait for a few seconds while the air
is purged.
2. Bring the knob back in the start position and turn the knob several
times to the
position. Check that the pilot has lit.
3. Continue to hold in the control knob for a further ten seconds to
ensure that the pilot flame is stable.
4. Release the knob. The pilot should remain alight.
6.2 Functional burner check
1.
Turn knob (B) to max. clockwise.
2. Turn the knob (A) more anticlockwise to the
position (large
flame). Now it is possible to light the main burner.
3. Turn knob B anticlockwise to max. The main burner should light.
Check for gas soundness at all joints with leak detection floud!
4. Check the ignition of the main burner on low and high setting.
5. Turn knob B clockwise till
{
. The main burner is off.
6. Turn the knob A to
{
. The pilot should go out.
3. Connect the wires to the gas valve (see fig. 12).
4. Check that there are batteries in the transmitter.
See "Replacing batteries", see chapter 10.4.4.
5. Set the on/off switch on the receiver to "on".
Setting the right transmission code
The receiver has to learn the code from the transmitter, which is already done at the
factory. However the code disappears if the receiver is disconnected from the mains for a
longer period, or when you use the transmitter out of the range of the receiver for more
then 15 times. The code then doesn’t match the code in the receiver
.
1.
Push the "mod" button on the receiver and hold it for 3 seconds.
2. The green control lamp will light up and stay on. Repeat this step
if it doesn't.
3. Push a button on the remote control. The control lamp on the
receiver should now go out.
4. Again push a button on the remote control. The lamp starts
flashing and will switch off eventually.
5. The receiver now recognizes the remote control. The remote
control now functions.
6. Check if you can hear a sound and the motor runs when you
push a button on the remote control.
fig. 12
A
B
fig. 13
