![background image](http://html1.mh-extra.com/html/faac/home-shield/home-shield_installation-and-use-instructions-manual_3115191017.webp)
Exit from the ADD DEVICES menu
Press the OFF key of the remote-control, or send an
OFF command with the keypad.
The control unit beeps once.
If there are no other adjustments to carry out, close the
enclosure of all the devices (except the control unit),
and then close the control unit battery compartment last
of all.
If inactive, the control unit will automatically
exit from the ADD DEVICES mode within 5 minutes,
and will remain in
MAINTENANCE PROGRAM
mode.
17
Ad
dition
light flashes,
- press the OFF key of the remote-control for about
one second; the control unit should should beep
twice,
- finish the insertion as described in step 2.
Put the control unit in
MAINTENANCE PROGRAM mode,
using a remote-control
The control unit must be in alarm OFF mode. Press
push-buttons 1 and 2 of a
Master remote-control, and
release them when the indicator light flashes. Press the
OFF key for a few seconds after the yellow indicator
light of the control unit flashes. You can now open the
control unit compartment within one minute.
Put the control unit in ADD
DEVICES mode, using a remote-
control
The control unit must be in MAINTENANCE
PROGRAM mode.
Press the ON Key of a remote-control for about 10 sec.
The control unit beeps once and the yellow indicator
light comes on with steady beam.
Attention:
Attention:
All the devices enabled with the method described
above are not memory-stored on the keypad.
Therefore a LEARNING session is necessary to
update the keypad’s memory before performing other
operations.