15
Adding devices to the system
AP
SUPP
TEST
2 secs.
Passage open signal
Peripheral units fault /
Telephone line fault
Discharged batteries
System sabotage alarm
Alarm memory-stored / In progress
Maintenance Program mode
Alarm ON / Alarm OFF
AP
EFF
TEST
Detectors
Remote-control
Control Keypad
Telephone transmitter
Siren
Passage open signal
Peripheral units fault /
Telephone line fault
Discharged batteries
System sabotage alarm
Alarm memory-stored / In progress
Maintenance Program mode
Alarm ON / Alarm OFF
2 secs.
Put the control unit in ADD
DEVICES mode
Select “Add devices” and confirm with OK
The control unit’s yellow indicator light comes on with
steady beam.
Put the control unit in
MAINTENANCE PROGRAM mode
The control unit must be in alarm OFF mode.
Type in the code (see page 18) on the control keypad,
confirm it, and then press the “configuration access”
push-button.
When INSTALLATION is shown, press OK and open
the control unit compartment.
From this moment on, the control unit is in
MAINTENANCE PROGRAM mode
Items displayed on control unit
One can verify the association of a device with the
control unit, by means of the latter’s indicator lights.
Indicator light 1 - Sensors
Indicator light 2 - Remote-control
Indicator light 3 - Control keypad
Indicator light 4 - Telephone transmitter
Indicator light 5 - Siren
Attention:
Attention:
One minute is available to open the control unit’s
compartment. When this time has elapsed, opening
the control unit trips the sabotage alarm. Send a stop
command from the control keypad or by means of a
pre-recorded remote-control.
Maximum number of devices for each system:
- 40 sensors,
- 4 outdoor sirens,
- 14 remote-controls,
- 4 control keypads.
select and
then confirm
select and
then confirm
OK
+
-
and
+
-
OK
and
DEVICES
-
+
OK
INFO
C
This is shown only
if the control unit's
compartment is
not already open
Ad
dition
