TEACH A RADIO CONTROL
When the XKP W is waiting for an operation, enter:
8 # Ch
Bring the two devices into contact with one another
within 25 s, as shown in the figure, then press:
#
(
keep it pressed until confirmation is given that the code
has been learnt, then release it
)
The code of the radio channel entered is transmitted
(Green LED on). At the same time, press the button of
the radio control and make sure that the confirmation is
given (the LED if the radio control will flash twice and
then switch off).
Repeat the procedure for each radio channel required. When using the radio
control for the first time, each radio channel has to be activated twice in quick
succession.
9.
LEARN THE RADIO CODE
This procedure allows the radio code of a channel to be ‘learnt’ from a SLH master
radio transmitter. This procedure must be carried out for each radio channel that
you wish to use.
Both Master XKP W and Slave XKP W units can learn the code. The teaching device
must be a SLH master radio transmitter.
When the XKP W is waiting for an operation, enter:
9 # Ch #
Bring the two devices into contact with one another within 25 s and transmit the
radio code from the radio control or from the teaching XKP W:
•
On the
radio control
press buttons P1 and P2 simultaneously, then release
them and press the channel number.
•
On
the teaching XKP W
follow the entire procedure indicated in
8
The XKP W learns the radio code on the channel entered, signals OK and waits for
an operation.
Repeat the procedure for each radio channel required. When using the XKP W for
the first time, each radio channel has to be activated twice in succession:
Easy Operation
enter:
User code
E
wait until the Green LED turns off, then press
E
Advanced Operation
enter:
#
user code
E Ch.
wait until the green LED turns off, then repeat
Ch
