4.
CHANGE THE PWD
Enter the PWD (maximum of 6 digits). Only numeric codes can be entered.
When the XKP W is waiting for an operation, enter:
4 # new PWD # new PWD #
5.
RESTORE FACTORY SETTINGS
This restores the XKP W to its factory settings: user code memory empty, direct
radio channel (button E) disabled, Easy Operation, PWD: 1 2 3 4, randomized radio
codes. When finished, the XKP W exits from programming mode and goes into
standby.
When the XKP W is waiting for an operation, enter:
5 # 5 #
6.
DIRECT RADIO CHANNEL BUTTON E
Button E can be used to activate a radio channel without having to enter a user
code (direct radio channel).
By default, the direct radio channel button E is disabled. To enable it, specify the
radio channel (Ch. no. from 1 to 4) to be activated. To disable it, press 0 instead of
the number of the radio channel.
When the XKP W is waiting for an operation, enter:
6 # Ch #
(enabled on the radio channel entered)
Or
6 # 0 #
(disabled)
7.
**NOT USED
8.
TEACH THE RADIO CODE
This allows a
master XKP W
to ‘teach’ the radio code of a channel to a target
device. This procedure must be carried our for each radio channel that you wish to
use. Only the master XKP W devices can teach the codes.
•
If the XKP W is installed on a new radio system, it must teach it to a Radio
Receiver.
•
If the XKP W is already being used on the radio receiver and you wish to
add a radio transmitter, the target device can be a radio control or an
additional Master or Slave XKP W.
Follow the procedures indicated below according to the target device.
