![background image](http://html1.mh-extra.com/html/faac/a100-compact/a100-compact_manual_3114570026.webp)
24
x2
ENGLISH
13.3B MICROSWITCH FOR SUPERVISION OF MOTOR LOCKING DEVICE
This accessory makes it possible to verify correct operation of
the motor lock and, if it stays locked while open, signals an error
via the control board.
Install the supervision microswitch as shown in Fig. 40 ref.
. For
electrical connection and programming, refer to the control
board/accessories section of these instructions.
14B SUPERVISION SENSOR
The supervision sensor is an accessory (magnetic sensor) to
which a relay can be connected via a connector (Fig. 41 ref.
) , in order to have a door closed / door not closed state (e.g.
to connect an alarm system).
Sensor installation procedure:
• Screw the magnet on the carriage nearest to the closing
contact point, using the threaded hole on the belt fitting
(fig.41 ref.
).
• Assemble the sensor to the bracket (fig. 41 ref.
), using
the plastic nuts. Inset a threaded plate on the seats of the
support profile, and install the bracket, using the screws (fig. 41
ref.
). Check if the sensor is in line with the magnet when
the leaf is closed.
16B INSTALLING THE CLOSING HOUSING
Cut the housing profile to the same length as the
support profile, except for 2mm to facilitate closing
housing blocking with side panels.
If the motor lock, and relevant release knob are present, drill a
hole of at least 18 mm taking care to centre the hole with the
release knob.
To facilitate the hole, use the line in fig.43 ref.
as a reference.
if the release knob is present, to open the housing,
dismantle the knob, unfastening the screw in fig.38
ref.
To install the housing, proceed as described in chapter 11A of
the assembled automated system installation.
15B INSTALLING THE EMERGENCY BATTERY KIT
• Fit two plates in the support profile as shown in Fig. 42.
• Secure the battery support on the support profile, using the
two supplied screws.
• For electrical connection of the battery board and for
programming, refer to the control board section of these
instructions.
17B START-UP OF THE AUTOMATED SYSTEM
• Manually check correct sliding of the leaves and of all the
moving elements.
• Carry out/check the electrical connections on the control
board of the power cables coming from the power supply
unit, from the motor, and from all accessories, consulting the
instructions of the control board.
• Use the raceways - suitably positioned (Fig. 35) - to route the
cables inside the support profile, thus preventing them from
coming into contact with moving parts.
• Set motor rotation direction according to type of door (refer
to the control board instructions).
• Connect the 115V/230V~ power plug to the specific con-
nector of the power supply unit (Fig. 29 ref.
)
Check if the switch in fig. 29 ref.
is correctly posi-
tioned (230V~/115V~).
• Check the efficiency of all installed accessories, especially
photocells and sensors
fig. 43
fig. 42
fig. 41