1. Clip on the wall profile cover trims. (They are designed to be a tight fit so take care).
2. Place all the cover caps on the profiles. (R and L on the inside of the caps indicate the handing of the caps looking
from the outside of the enclosure).
3. Place the Hinge Cover caps over the screw heads.
4. Stick on the Branding Badge.
5. Seal vertically the full length of the wall profiles/wall profile trims, where they meet the tiles on the inside of the
enclosure, using bathroom sealant. Also seal vertically the full length of the wall profiles where they meet the
tiles on the outside of the enclosure, using bathroom sealant.
6. Seal horizontally the aluminum profiles and the glass panels on the outside of the enclosure at the bottom where
they meet the tiles and the tray using bathroom sealant.
•
(Please leave the sealant 24hrs to cure before use).
•
IMPORTANT: Failure to follow the procedure in steps 5 and 6 can result in serious water damage and is
not covered by the guarantee.
•
(If you are fitting the enclosure with integrated water delivery please refer to your valve instructions to
complete the installations).
Step 6 - Fix the Cover Caps and Seal the enclosure.
FA - Freedom Arc Dec 2009:CQB
4/5/10
12:05
Page 7
