1. Position the wall profiles using the guides on the tray, the lip of the profiles face towards the inside of the
enclosure (look at point 2 above).
•
The wall profiles must be vertically level. Check using a spirit level. (The bubble should be in the centre of
the two lines on the spirit level).
2. Mark the locations for the drill holes using a pencil.
•
Use the supplied wall plugs if fitting the wall profiles into brick or block work, iF fitting into plasterboard,
the appropriate fixings will need to be used.
3. Drill the holes using 6mm masonry bit (not supplied). Then push the wall plugs in beyond the depth of the tile.
4. Apply sealant the width of the wall profiles, where they meet the tiles and the tray. (Important: failure to carry out
this procedure can cause serious water damage and is not covered by the guarantee).
5. Fix the Wall Profiles using the 40 mm screws (supplied).
6. Apply Sealant to the inside of the wall profiles, where they meet the tray. (Important: failure to carry out this
procedure can cause serious water damage and is not covered by the guarantee).
•
(If you are fitting the enclosure straight to floor see the guidance page at the back of these instructions)
WALL PROFILE LIP
Step 2 - Fixing the Wall Profiles
FA - Freedom Arc Dec 2009:CQB
4/5/10
12:05
Page 3
