Chapter 1
About Replacing Slide Rails
1 - 4
3. Install the two rail-locking brackets (found in the Accessory Kit
bubble bag) using the 6-32 screws provided. (These are the 4
smaller screws. Save the 2 larger screws to lock the chassis into the
equipment rack in step 14.) The following figure shows an installed
locking bracket.
4. Assemble the front slide-rail mount brackets (the short ones) to
slide-cabinet members, as shown below, using the wing nuts
provided.
Ensure the three-hole side of the bracket is facing out
(as shown
in the following figure.)
Ensure the ends of the rail-mount brackets are 1 1/2 inches from the
ends of the slide-cabinet members before tightening the wing nuts.
This ensures the chassis front is flush with the front of the
equipment rack rails.
5. To determine the location of the rear-rail mount brackets, measure
the inside surface of the front rail to the inside surface of the back
rail of the equipment rack where the chassis will be installed.
Summary of Contents for ARX-1500
Page 1: ...ARX 1500 2500 Slide Rail FRU PUB 0243 00 ...
Page 2: ......
