Chapter 1
About Replacing Slide Rails
1 - 2
Power Details:
Supply State
------ -----
A Online
B Online
General Recommendations for Rack Mounting
Although not required, a 1U space between units makes it easier to remove
the unit from the rack if the unit requires service. A 1U space between units
also provides additional cable routing options.
We recommend 100 mm spacing from the front panel of the unit to the rack
front or rack door. This provides enough room for routing the cables without
excessive bending or insulation damage.
Important
To prevent personal injury or damage to the unit, we recommend that at
least two people perform the installation.
If only one person is installing the unit, we require a shelf or similar device
to support the unit.
Important
Do not power on the platform until the management serial console or the
management network is connected to the unit.
Slide-Rail Mounting Hardware
The slide-rail mounting hardware includes the following:
• Slide rails for the left side (1 pair)
• Slide rails for the right side (1 pair)
• Mounting brackets–front and rear (2)
• Thumbscrews (8)
• Wing nuts or kep nuts (8)
The slide-rail mounting hardware also includes the rail-locking bracket kit,
which is located in the bubble bag in the box the switch was shipped in. The
kit includes:
• Rail-locking brackets (2)
• #6-32 pan head screws (4)
• #8-32 pan head screws (2)
Summary of Contents for ARX-1500
Page 1: ...ARX 1500 2500 Slide Rail FRU PUB 0243 00 ...
Page 2: ......
