Problem
Cause
Solution
Inside diameter of
ring too big after
clinching
Slot (440195.3) worn
Replace slot (440195.3)
Wrong slot (too short) used
(440195.3)
Verify and replace slot
if necessary (440195.3)
Slot plate broken
(294247)
Replace slot plate
(294247)
Wrong piston rod (288458)
(too short)
Verify and replace piston
rod (288458)
Low power:
1.Air pressure set too low
2.Air leaks in supply hose
3.Air leak in tool
4.Throttle valve A not
adjusted properly
Verify pressure:
1.Check air pressure
2.Replace air supply hose
3. See manual
4. Adjust throttle valve A
Wrong clinchers used
(184206,184207)
Verify and replace clinchers
if necessary
(184206,184207)
Worn clinchers
(184206,184207) or
worn clincher bush
(092210)
Verify and if necessary
replace clinchers
(184206,184207) or
clincher bush
(092210)
Worn rollers (348056)
Replace rollers (348056)
Wrong rollers (348056).
Too small
Verify and replace rollers
(348056)
Defective CL45-rings:
Wire too hard
Rough surface
Cut-off burrs
Send ring sample to tool
supplier for testing
10
Trouble Shooting
