F.u.n.k.e. F10185, Installation & Operation Manual

Page: 44 / 81

FSG 90 System
5 SET-UP Procedure
38
FAV_D10024 December 2014
5 SET-UP Procedure
This Section contains a description of the SET-UP procedure to be carried out by an
experienced avionics technician . To carry out the SET-UP procedure the radio must
be completely wired and ready to use.
DANGER!

During SET-UP procedure, the radio is partly unable to work. The
radio can neither receive nor transmit!

NEVER carry out a SET-UP during flight or whilst driving a car!
Perform SET-UP only whilst standing safely on the ground!

Before the next flight or application, check all settings of the radio
and cockpit instruments for correct function!
IMPORTANT!

The
FSG 90(X)
is factory pre-set for check and testing purposes. To
achieve maximum performance it is therefore absolutely necessary to
optimize the radio and to adapt the accessories used.

To carry out the SET-UP the radio must be ready for operation (antenna
connected, power supply OK, operational microphone/s, headset/s).

If a headset is used, turn its volume control to maximum, if applicable.

All frequencies, channel names, channel memory numbers etc., shown in
the following illustrations, are
examples !
The following settings can be selected or adjusted (in order):
1. Adjusting the automatic squelch threshold
2. Adjusting the microphone sensitivity
3. Adjusting the Intercom volume (headset)
4. Adjusting the Transmit Sidetone volume (headset)
5.
Adjusting the headset volume (during Receive, independent from
speaker volume)
6.
Selecting '25 kHz only' channel spacing or combined 8.33 kHz / 25 kHz
channel spacing. Confirmation with
STO
starts new mode at once!
7. Deleting occupied channel memories (one after the other)
8. Selecting AF External via A/C loudspeaker ON (1) or OFF (0).
9.
Selecting 'CHANNEL MODE' only (1) or 'FREE FREQUENCY
SELECTION' (0)
10. Selecting 'Transmitter Blocking' during receive ON (1) or OFF (0)