F-SECURE CLIENT SECURITY 7.00, Administrator'S Manual

Page: 187 / 315

CHAPTER 5 187
Step 3. Changing Spyware Scanning to Quarantine
Automatically Configuration
Configure the Default Spyware Handling settings:
1. If you want to make sure that users cannot allow any spyware or
riskware to run on their computers, make sure that
Permit users to
allow spyware is set to Not allowed .
2. Set spyware scanning to quarantine all detected spyware
automatically by clicking the
Change spyware protection to
automatically quarantine all new spyware link . Click Yes in the
confirmation dialog.
3. Check that the real-time spyware scanning settings are valid for the
managed domain. They are located in the
Spyware Scanning on File
Access section.
4. Check that the manual spyware scanning settings are valid for the
managed domain.They are located in the
Manual Spyware Scanning
section.
Step 4. Distribute the Policy
Distribute a policy with the spyware handling settings to the whole
domain:
1. Click to save the policy data.
2. Click to distribute the policy.
5.8.3 Launching Spyware Scanning in the Whole Domain
In this example a manual spyware scan is launched in the whole domain.
This will partially clean out the
Spyware and Riskware Reported by Hosts
table
1. Select Root in the Policy Domains tab.
2. Go to the Settings tab and select the Manual Scanning page.
3. In the Manual Spyware Scanning section, select Scan for spyware
during manual virus scan.