Ezy-Lift 2000, Installation Manual, Page: 8 / 21

8
8
short Power Cord. Position the short cord from the battery to a clear area of the truck’s engine compartment
firewall. Mount the Fuse Box to the firewall in this area. Connect the short cord to the Fuse Terminal closest
to the battery. Pass the end of the long up into the engine compartment and connect it to the other Fuse Termi-
nal. Place the Fuse Box cover on the Fuse Box and secure.
Run the long Power Cord under the truck bed and attach it to the chassis
with the supplied tie wraps. Pass the power cord end through the hole in the
bottom of the pump compartment of the Unit Frame.
Feed the positive up through the remaining hole, which should be the hole
closest to the tail-gate. Attach the red power to the power terminal marked
“Line” on the On/Off Switch. Run the ground line from where it is secured on
the lift frame run it down through the same hole and mount it to the chassis
under the truck. Insure that the terminal attaching points are clean to bare
metal. Connect the Power Cord to the truck’s battery terminal.
Check the Remote Control and the Hydraulic Fluid in the Lift Pump