Ezy-Lift 2000, Installation Manual, Page: 18 / 21

18
18
Inspect for corrosion and treat as necessary
Inspect electrical system for corrosion or damage and repair or replace as necessary.
Inspect all bolts, including frame attachment to cargo bed, frame to arm assemblies, gusset and winch, tighten and/
or replace as necessary.
Inspect winch housing and motor for any signs of wear or problems, repair or replace as necessary.
TROUBLE SHOOTING
WARRANTY
Ezy-Lift, Inc. warrants the Ezy-Lift product to the original Buyer against defective materials and parts for one (1)
year from the date of purchase Ezy-Lift’s sole and exclusive liability, and the Buyer’s sole and exclusive remedy,
under this warranty, is the repair or replacement of any materials or parts determined to be defective. In no event
shall Ezy-Lift be liable for incidental or consequential damages, including, but not limited to, inspection or transpor-
tation cost, cost of cover, loss of profits, loss of use, and damages or injury of any kind based upon claim for breach
of warranty.
This warranty does not cover breaking or fraying of the wire cable, cost of labor for field repairs, transportation
charges in connection with replacement or repairs of defective parts, or nay damage as a result of misuse, neglect,
overloading, accident, impcabler installation, maintenance or repair, unauthorized alteration, or use of the product
beyond the range of normal usage.
To obtain warranty service, contact EZY-LIFT at 713.589.9449 during business hours, 8:00 AM till 5:00 PM, Cen-
tral Standard Time, Monday thru Friday, excluding holidays. Be prepared to provide: (1) name, address, and phone
number; (2) proof of purchase; (3) unit serial number; and (4) an explanation of the problem.
This warranty is the only warranty made by Ezy-Lift and it cannot be amended or amplified by any party.
Problem Possible Cause Possible Solution
Lift Arms will not raise or lower Unit Off/On switch is “Off” Turn the switch “On”
A.) Remote Control assembly
not properly plugged in Remove and re-insert the Remote
Control assembly
B.) Poor electrical connection Check & repair or replace the
Remote Control assembly
C.) Vehicle battery charge is low Recharge or replace battery
D.) Fuse at vehicle battery blown Replace Fuse
E.) Faulty contactor Contact factory authorized agent
for repair or replacement
Winch will not operate or it runs
in one direction A.) Remote Control assembly
not properly plugged in Remove and re-insert the Remote
Control assembly
B.) Poor electrical connection Check & repair or replace the
Remote Control assembly
C.) Vehicle battery charge is low Recharge or replace battery
D.) Fuse at vehicle battery blown Replace Fuse