9
10
6. User Code (UC)
6-1 The default user code is “1234”. During initial installation, delete the default user
code, and then set the new user code.
6-2 A total of 6 user codes can be saved.
6-3 The user code can only be used to unlock the door and
6-4 The user code
6-5 The user code can be deleted or added at anytime as needed.
7-1
The same user code can be reset after being
deleted.
7-2 The programming code is needed to delete
8. Delete all user codes
8-1
The original user codes can be reset again.
8-2 After deleting all user codes, the automatic lock and the button lockup
functions set previously will automatically be disabled. The
user code
8-3 The programming code is required to delete
9. Temporarily
user code
9-1 This will temporarily disable all user codes. The automatic lockup and keypad
lockup functions that were set previously will automatically be disabled. A key
must be used to lock and unlock the door.
9-2 To restore the code function and other electronic functions, repeat the steps for
“Temporarily
user code”.
10.
one-time user code
10-1 After the one-time user code is entered and used, it is
and won't be
able to open the door again.
10-2 The same one-time user code can be set repeatedly.
10-3 The programming code is needed
to set other functions.
must be 4-10 digits in length.
User codes can be deleted individually.
individual codes.
All user codes can be deleted at once.
door can only be locked
or unlocked with a key. The original functions will be restored once the
is set.
all user codes.
disable
disable
Create
disabled
for setup.
7. Delete individual user code
11. Restore the default PC & UC
to delete
12. Unlock
a registered
12-2 To unlock with the keypad
1. Place the hand within 2 cm of the keypad or press any key once to light up the
keypad.
2. 4 numbers will appear on the keypad.
Press them in any order.
3. Enter the user code.
13. Lock
The door can be locked from
the inside
14. Automatic lockup
14-1 The timer (10-99 seconds) of automatic lockup can be set up by the user as
needed. (The default timer is 30 seconds after the system is unlocked.)
14-2 To disable the automatic lockup, please repeat the steps for “Automatic lockup”.
15. Code protection
If the user code is entered incorrectly over 5 times, the system will initiate the
protective function and disable the keypad for 45 seconds.
16. Backlight
When the hand is within 2 cm of the keypad, the backlight will light up for about 5
seconds, making it easy to operate lockset in the dark.
Use this function when forgetting the programming code or
all settings.
12-1 The door can be unlocked by entering
user code or the key from
outside, or pressing the lever down / turning the knob from inside.
4. Press the button.
When the light for the key goes out, the system is unlocked.
When the keypad lights up, the user may press the keypad, press button or use
the key and automatic lockup function to lock the door.
by turning the interior turn-piece.
