XTP T VGA Transmitter • Installation
12
Remote power
The XTP T VGA can be powered remotely through an XTP Power Injector or through an XTP
matrix switcher.
ATTENTION:
•
XTP remote power is intended for indoor use only. No part of the network that uses
XTP remote power should be routed outdoors.
•
XTP à distance est destiné à une utilisation en intérieur seulement. Aucune partie
du réseau qui utilise l’alimentation XTP à distance ne peut être routée en extérieur.
Power injector
To power the XTP T VGA remotely with an XTP Power Injector, power a connected receiver
locally (see
on page 10) and connect an XTP Power Injector to the XTP
cable run along the XTP ports (see the
XTP Power Injector User Guide
at
for more installation information).
POWER
12V
--A MAX
Rx G
Tx
RS-232
IR
Rx
Tx
AUDIO
LOOP-THRU
UNIVERSAL
XTP T VGA
LAN
SIG LINK
XTP OUT
RESET
INPUTS
OVER XTP
LAN
SIG LINK
XTP IN
POWER
12V
HDMI
1A MAX
Rx G
Tx
RS-232
IR
Rx
Tx
−
+
−
+
L
R
1
2
OVER XTP
AUDIO
OFF
ON
S/PDIF
RESET
XTP R HDMI
RELAYS
OUTPUTS
AUDIO
XTP
PWR
XTP PWR
100-240V 50/60 Hz
---A MAX
Power
Extron
XTP R HDMI
XTP Receiver
Extron
XTP PI 100
XTP Power
Injector
Shielded Twisted
Pair Cable
Remote
Power
12V Local Power
Supply
Extron
XTP T VGA
Universal XTP Transmitter for VGA
Figure 8.
Typical Point-to-Point Application with Remote Power
NOTE:
The power injector provides remote power up to 330 feet with a shielded twisted
pair cable with 24 AWG wire.
XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power to
connected XTP devices (see the appropriate XTP matrix switcher user guide at
for more details). To manage available power from the XTP matrix
switcher, use the XTP System Configuration Software with the matrix switcher.
