Extron electronics XTP T VGA, User Manual, Page: 13 / 42

XTP T VGA Transmitter • Installation 5
D RS-232 Over XTP port — To pass bidirectional serial signals between
XTP-compatible devices, connect a control device to the 5-pole captive
screw connector (see
figure 2 ,
D
on the previous page). The port includes
only the 3 poles labeled “RS-232.”
IR Over XTP port — To transmit and receive IR signals (up to 56 kHz),
connect a control device to the 5-pole captive screw connector (see
figure 2 ,
D
). This port includes the 2 poles labeled
“IR” and shares the ground pole with the RS-232 port.
NOTE: RS-232 and IR data can be transmitted simultaneously (see RS-232 and IR
Over XTP Communication on page 9 for wiring details).
E
XTP output connector — Connect a twisted pair cable to the RJ-45 connector
labeled “XTP OUT” on the XTP T VGA (see figure 2 ,
E
on the previous page) and the
XTP input connector on an XTP receiver or XTP matrix switcher to pass all signals (see
TP Cable Termination and Recommendations on page 7). This cable carries the
following signals:
•
Digital video
•
Digital audio
•
Bidirectional RS-232 and IR commands
•
Remote power
•
Ethernet communication
•
System communication
Signal LED indicator — Lights green when the XTP T VGA outputs a
video signal or a test pattern.
Link LED indicator — Lights yellow when XTP devices are connected
and communication is established.
ATTENTION:
•
Do not connect this connector to a computer data or telecommunications
network.
• Ne connectez pas ce connecteur à un réseau de données informatiques ou à
un réseau de télécommunications.
• XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see
Remote power on
page 12).
• XTP à distance est destiné à une utilisation en intérieur seulement. Aucune
partie du réseau qui utilise l’alimentation XTP à distance ne peut être routée en
extérieur (voir
Remote power à la page 12).
F LAN connector — Connect a control device or device to be controlled to the RJ-45
connector labeled “LAN” (see figure 2 ,
F
on the previous page) for 10/100Base-T
Ethernet communication through this pass-through port. LEDs on the connector
indicate link and activity status.
G Power connector and LED — Connect the external 12 V, 1.0 A power supply to the
2-pole captive screw connector (see figure 2 ,
G
on the previous page). For wiring
considerations, see Power Connection on page 10. The Power LED lights to
indicate the device is receiving power.
NOTE:
The XTP T VGA can also be powered remotely (see Remote power on
page 12).
IR
Tx Rx G Tx Rx
RS-232
Signal
Link
IR
Tx Rx G Tx Rx
RS-232