XTP T USW 103 4K Switcher • Installation
7
XTP Interconnection
F
(see figure 2 on page 5) — Connect an XTP twisted
pair receiver or matrix switcher (see
Twisted Pair Cable Termination and
Recommendations for XTP Communication
on page 11) to the RJ-45 XTP output
connector. The twisted pair cable carries the following signals:
•
Digital video
•
Digital audio
•
Bidirectional RS-232 and IR commands
•
Ethernet communication
•
System communication
Signal LED indicator
— Lights green when the XTP T USW 103 4K outputs
a video signal or a test pattern.
Link LED indicator
— Lights yellow when XTP devices are connected and
communication is established.
ATTENTION:
•
Do not connect this connector to a computer data or telecommunications
network.
•
Ne connectez pas ce connecteur à un réseau de données informatiques ou à
un réseau de télécommunications.
G
— Connect a control or controlled device to the pass-through LAN
connector for 10/100Base-T Ethernet communication. LEDs on the connector indicate
link and activity status.
H
— To pass bidirectional serial signals between
XTP-compatible devices, connect a control device to the 5-pole captive screw
connector. The connector includes only the 2 poles labeled “RS-232” and shares the
ground pole with the IR poles.
— To transmit and receive IR signals (up to 56 kHz), connect
a control device to the 5-pole captive screw connector. The connector includes the
2 poles labeled “IR” and shares the ground pole with the RS-232 poles.
NOTE:
RS-232 and IR data can be transmitted simultaneously (see
on page 13 for wiring details).
Signal
Link
Summary of Contents for XTP T USW 103 4K
Page 6: ......
