VoiceLift Pro Microphones User Guide • VLM Kit Installation and Operation
15
NOTES:
•
Once initiated, pairing mode is enabled for 30 seconds. Users must repeat the
process if they have exceeded the 30 second pairing window or if pairing was
not successful.
•
Receiver Pairing/Discovery mode can also be enabled remotely via SIS
comands.Commands can be sent to the receiver through direct USB
connection or through PVS switcher connection.
•
If both LINK 1 and LINK 2 LEDs flash when initiating pairing mode on the
VLR 302, this means that both LINK slots are currently occupied and paired to
microphones.
2.
Follow the steps below for your microphone model:
•
For the VLP 302
,
ensure that the microphone is powered
off
.
NOTE:
The VLP microphone must be in “teacher” mode (DIP switch in the
down position) in order to pair (see
2
on page 13).
Then, press and hold the
Power
and
Function
buttons (see
A
and
B
at
right) simultaneously for 4
seconds until the status
LED blinks red and green,
indicating pairing mode has
started.
•
For the VLH 302
:
Ensure that the microphone
is powered
on
.
NOTE:
The VLH microphone must be in “student” (on)
mode in order to pair.
Then, press and hold the
LINK
button, located beneath the
battery cover (see
C
at right), for 4 seconds.
The microphone status LED changes from solid amber to alternating
red and green, indicating that pairing mode has started.
NOTE:
The receiver assigns the microphone to the first available LINK slot. If the
microphone is paired successfully, one of the LINK LEDs on the VLR receiver lights
solid green.
3.
After pairing the microphones, verify that they have been set up properly as shown in
C
B
A
Summary of Contents for VoiceLift Pro VLS 3001
Page 8: ...viii ...
