VoiceLift Pro Microphones User Guide • VLM Kit Installation and Operation
13
Setting up the Microphones
VLP 302 Pendant Microphone
1.
Verify that the battery is installed and fully charged.
2.
Set the microphone(s) for either "teacher" or "student" mode using the DIP switch,
accessible from beneath the battery cover (see
2
below):
•
In
teacher mode
(default), all microphone
features are fully functional. Set the dip
switch to the OFF (down) position to
enable “teacher” mode.
•
In
student mode
, all buttons are
disabled except for power. Set the
dip switch to the ON (up) position to
enable “student” mode.
3.
Apply the appropriate label (provided) to identify the
microphone (see
3
at right).
4.
To wear as a pendant microphone:
Push the lanyard into the guides on the
lanyard lock (see
a
at right).
Open the microphone clip (
b
).
Slide up the lanyard lock under the clip,
then release the clip (
c
).
Place the lanyard
around your neck and
adjust the
microphone position
by sliding it up so it
rests approximately
6 inches (15.2 cm)
below your chin.
5.
Turn the microphone(s) on by holding the power button for
three seconds.
NOTE:
Each VLM kit includes microphones and a
VLR 302 receiver that have already been paired. If there
is a need to pair a microphone, follow the steps on the
next page.
6.
Speak in a normal tone of voice, adjusting the volume level as
necessary.
7.
When finished, return the microphone to the charging station.
2
3
Status
LED
5
6
~
6
”
c
b
Press to
open clip
Lanyard
Lock
a
Summary of Contents for VoiceLift Pro VLS 3001
Page 8: ...viii ...
