VoiceLift Pro Microphones User Guide • VoiceLift System Installation
21
3.
Cover plate
— Loosen, but do not remove, the two
screws on the top of the cover plate, as shown on the
right. Next, slide and remove the cover plate.
4.
Using Flexible Conduit
— When using flexible
conduit, insert the conduit into the cover plate
opening using an appropriate conduit adapter,
and secure the conduit adapter to the plate, as
shown at right.
When using speaker wires without a conduit,
secure the cable clamp
adapter (included)
to the cover plate and insert
the wires through the
clamp. Tighten the
screws, as shown
below.
5.
Wire the speaker
—
a.
Pull the wires from the amplifier through and out of the conduit, if a conduit is used.
b.
Route the two wires from the amplifier through the cover plate hole. See the wire gauge
table on page 1.
c.
Strip 3/16 inch (5 mm) from the ends of the two speaker wire leads (+ and -) coming
from the amplifier. Keep the wire strands together by twisting them (do not tin the wires),
and secure the wires to the input terminals of the speaker while observing the correct
polarity.
d.
Connect the red, positive (+) wire to the + speaker
terminal and connect the black, negative (-) wire to
the - speaker terminal, as shown at right.
6.
Replace the cover plate and tighten the two cover plate screws that were loosened in step
3
.
Flexible Conduit Adapter
Flexible Conduit
Cover Plate
Secondary
Attachment
Point
Rear of Speaker
Cover Plate
Loosen, do not remove.
Cable Clamp Adapter
Cover Plate
Secondary
Attachment
Point
Rear of Speaker
Red Wire
Black Wire
From Amplifier
One Speaker
Summary of Contents for VoiceLift Pro VLS 3001
Page 8: ...viii ...
