7
Product Category
Step 9 — Connecting the TLP Pro 725C
The TLP Pro 725C is Power over Ethernet compliant and must be powered through the LAN/PoE port (see
figure 11
,
A
, on the
next page). Extron recommends the Extron XTP PI 100 power injector. Your power injector may look different.
An Extron IP Link Pro control processor must also be connected to the same network as the TouchLink Pro touchpanel.
ATTENTION:
•
Do not power on the touchpanel until you have read the Attention in the “Base Features” section of the
TLP Pro 725C
Series User Guide
.
•
Ne branchez pas l’écran tactile avant d’avoir lu la mise en garde dans la section « Base Features » du
TLP Pro 725C Series
User Guide
.
1.
Connect the touchpanel to a PoE power injector (not provided) using a
twisted pair cable, terminated with an RJ-45 connector (see figure 9,
1
).
2.
Connect the power injector to the LAN through a network switch (
2
).
100-240V
~
50-60Hz
0.4A MAX
XTP
PWR
XTP PWR
To network switch
To touchpanel
1
1
2
2
Figure 9.
XTP PI 100 Power Injector
figure 9
Front Panel Features
A
LCD screen
— The TLP Pro 725C series has a 7-inch
screen with a 1024x600 resolution.
B
Motion sensor
— Detects motion between three to five feet
from the touchpanel, and at least 15° from the center axis.
•
When no motion has been detected for a user-defined
period of time, the touchpanel enters sleep mode.
•
When motion is detected by the sensor, the screen
display is restored and active.
C
Communication LED
— This LED shows the configuration
and connection status of the touchpanel:
•
Unlit during normal operation (the touchpanel is
configured and connected to an IP Link Pro control
processor).
•
Blinks red if the touchpanel has been configured but is
not connected to an IP Link Pro control processor.
•
Permanently lit if the touchpanel has not been
configured and is not connected to an IP Link Pro
control processor.
The indicator can be toggled between enabled and
disabled, using the
Setup Menu
(see page 8).
D
Light sensor
— This sensor monitors ambient light level
and adjusts screen brightness, based on the settings
configured using the
Setup Menu
.
A
A
B
B
C
C
D
D
B
B
F
F
E
E
Figure 10.
TLP Pro 725C Front Panel and Enclosure Features
Enclosure Features
E
Activation Switch
– the left side of the lid hinge mechanism contains a switch. When the lid is closed, the switch sends the
screen into sleep mode. When the lid is opened, the screen display is restored and active.
When the lid is shut, the screen is not activated by motion near the touchpanel.
F
Speaker
— A single speaker, located on the side of the enclosure, provides audible feedback for the user.