3
Product Category
NORTH
AMERICA
NORTH
AMERICA
MK
MK
EU/MK
EU/MK
WALL
WALL
WALL
WALL
NORTH
AMERICA
NORTH
AMERICA
NORTH
AMERICA
NORTH
AMERICA
EU
MK
EU
EU
EU
MK
Figure 2.
Mounting Plates for 5 inch models (left) and 7 or 10 inch models (right)
NOTE:
The TLP Pro 725M, TLS 725M, TLP Pro 1025M, and TLS 1025M TouchLink panels use the same mounting plate.
Without a wall box
If the wall box is not required by local building codes, you can mount the TouchLink panel directly into drywall.
1.
Use the mounting plate as a template to mark the wall or download the cut-out template for your product from
Place the template or mounting plate against the wall or furniture in a suitable location and ensure that it is level.
2.
Mark the position of the hole and cut the wall.
•
For the 5 inch models, this hole is 2.4 inches (61 mm) wide x 2.1 inches (53 mm) high.
•
For the 7 or 10 inch models, this hole is 3.5 inches (89 mm) wide x 2.0 inches (51 mm) high.
3.
Mark the slots labeled
WALL
(5 inch models) or
MK
(7 or 10 inch models) (see figure 2) and drill the two pilot holes. Extron
recommends using two Molly bolts or SnapToggle bolts.
4.
Secure the mounting plate to the wall (see
,
2
, on the previous page).
5.
Complete the installation as described in
on the previous page.
figure 2
Front Panel Features
NOTE:
Figure 3 shows the front panel of the TLP Pro 725M.
The front panels of all the TouchLink panels have the same
features and are almost identical apart from the size.
A
Motion sensor
— Detects motion between three to five feet
from the TouchLink panel, and at least 15° from the center
axis.
•
If the sleep timer has been set (see
page 6), and no motion has been detected for a
user-defined period of time, the TouchLink panel enters
sleep mode.
•
If Wake on Motion has been set (see
), and
motion is detected by the sensor while the screen is in
sleep mode, the screen display is restored and active.
Extron
A
A
A B
B
B C
C
C A
A
A
D
D
D
E
E
E
E
E
E
Figure 3.
TLP Pro 725M Front Panel
B
Communication LED
— (
TLP Pro models only
) Shows the configuration and connection status of the touchpanel:
•
Unlit during normal operation (the touchpanel is configured and connected to an IP Link Pro control processor).
•
Blinks red if the touchpanel has been configured but is not connected to an IP Link Pro control processor.
•
Lights steadily red if the touchpanel has not been configured.
The indicator can be toggled between enabled and disabled, using the
.
C
Light sensor
— Monitors ambient light level and adjusts screen brightness.
D
Capacitive touchscreen
•
The TLP Pro 525M series and TLS 525M have a 5 inch screen with a 800x480 resolution.
•
The TLP Pro 725M series and TLS 725M have a 7 inch screen with a 1024x600 resolution.
•
The TLP Pro 1025M series and TLS 1025M have a 10.1 inch screen with a 1280x800 resolution
figure 3