6
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide
on the Extron website.
© 2020 - 2021 Extron Electronics — All rights reserved.
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters:
Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
TLP Pro x25M and TLS x25M Series TouchLink panels • Setup Guide (Continued)
Reset Modes: a Brief Summary
These TouchLink panels provide the following reset modes (see the
TLP Pro 525, 725, and 1025 Series User Guide
for complete
information):
•
Use Factory Firmware
— With the unit powered off, press and hold the
RESET
button (see
,
B
) while
reapplying power to the unit. Use this mode with Toolbelt software to replace firmware in the event of conflicts arising from
uploading a firmware update.
•
Reset All IP Settings
— Press and hold the
RESET
button for 6 seconds. After the
RESET
LED (
C
) blinks twice, release and
momentarily press the
RESET
button. Use this mode to reset all network settings without affecting user-loaded files.
•
Reset to Factory Defaults
— Press and hold the
RESET
button for 9 seconds. After the Reset LED blinks three times, release
and momentarily press the
RESET
button. Use this mode to return the TouchLink panel to factory default settings.
NOTES:
•
The factory configured passwords for all accounts on this device have been set to the device serial number.
Passwords are case sensitive.
•
If the device is reset to default settings, the password will be the default password configuration. The default
password is
extron
(for either admin or user).
•
Enable or Disable the DHCP Client
— This mode toggles between DHCP enabled and DHCP disabled. Press the
Reset
button five times, consecutively. After the fifth press, do not press the button again within 3 seconds. If DHCP was enabled, it
is now disabled and the
Power
LED blinks three times. If DHCP was disabled, it is now enabled and the
Power
LED blinks six
times.
Reset Modes
Status
Display
Audio
Advanced
Exit
Network
Info
Model:
TLP Pro 725M
Part Number: 60-1563-02
Firmware
Version:
1.02.0001-b001
Network
IP Address:
DHCP:
Host Name:
Off
192.168.254.251
TLP-AB-CD-EF
Display
Resolution:
GUI Project:
Sleep Timer:
1024x600
N/A
5 Minutes
Audio
System Volume:
System Mute:
Off
99
Advanced
Controller IP:
N/A
Project Size:
N/A
Bootloader
Version:
1.03.0000
Figure 6.
Setup Menu: Status Screen for TLP Pro 725M
Setup Menu
Figure 6 shows the Status screen for the TLP Pro 725M. The
screen for the TLP Pro 525M, TLP Pro 1025M, and the TLS
models are similar.
Press the
MENU
button (
A
) to open the setup menu.
Select any of the five available screens (
Status
,
Network
,
Display
,
Audio
, and
Advanced
) by pressing the appropriate
button in the navigation bar at the top of the screen (for more
information, see the
TLP Pro 525, 725, and 1025 Series User
Guide
).
68-2831-55 Rev. B
10 21