Extron electronics TLP Pro x25M Series, Setup Manual, Page: 2 / 6

2
TLP Pro x25M and TLS x25M Series TouchLink panels • Setup Guide (Continued)
Configure the TouchLink Panels
TLP Pro TouchLink panels
— The GUI Designer Help File , the Global Configurator Help File , and the Toolbelt Help File provide
step-by-step instructions and detailed information, including an introduction to the software and sections on how to start a project
and configuration.
Global Scripter provides an Extron-exclusive Python library (ControlScript
®
) and Global Scripter modules to get you started (see the
Global Scripter Help File
).
TLS scheduling panels — The Room Agent Help File , User Guide , and Quick Start Guide provide information about configuring these
panels.
Mounting
All these panels can be wall-mounted, either using a UL-listed junction box, an external wall box, or directly into drywall or furniture.
Suitable mounting accessories can be found at
www.extron.com .
ATTENTION:
• Do not install TouchLink panels in a fire resistant rated wall or partition assembly.
• Veuillez ne pas installer les écrans TouchLink dans un mur protégé par un dispositif coupe-feu ou dans une cloison.
• All structural steps and electrical installation must be performed by qualified personnel in accordance with local and
national building codes and electrical codes.
• Toute étape structurelle et installation électrique, doit être effectuée par un personnel qualifié, conformément aux
codes du bâtiment, aux codes incendie et sécurité, et aux codes électriques, locaux et nationaux.
With a Wall Box or Junction Box
Some local building codes require the TouchLink panel to be mounted in a junction box. Junction boxes or wall boxes must be
purchased separately. Figure 1 shows the TLP Pro 725M. Installation for the other panels is very similar.
NOTES:
•
The 5 inch models mount to a 1-gang junction box. The
US 1-gang junction box should be installed so that the
long side is horizontal. EU or MK 1-gang junction boxes
should be installed in the standard orientation.
•
The 7 and 10 inch models mount to a 2-gang junction
box.
•
Extron provides four 3/4" #6-32 Philips pan head screws
for mounting to US junction boxes
•
Extron provides two 16 mm M 3.5 Philips pan head
screws for mounting to MK junction boxes
•
EU junction boxes are usually provided with their own
screws.
With a wall box
1.
Install a junction box or wall box (see figure 1,
1
),
following the instructions provided by the manufacturer.
2.
Fasten the mounting plate to the wallbox ( 2 ) with
the provided screws. Use the mounting holes that
are appropriate to the junction box you are using (see
figure 2 on the following page).
3.
Run and connect cables to the back of the TouchLink
panel (see
Rear Panel Features on the following page).
4.
The mounting plate for the 5 inch TouchLink panel has
two hooks (one in each top corner). The mounting plate
for the 7 and 10 inch panels has four hooks (
3 ), one in
each corner (see
figure 2
).
Position the touch panel so that the mounting slots (see
figure 4 , D , on page 4) in the rear of the TouchLink
panel align with these hooks.
5.
Move the TouchLink panel inward and downward so that
the panel sits securely on the hooks, and the tongue at
the bottom of the mounting plate (
4 ) sits in the groove
in the bottom of the panel (see inset, figure 1,
5
).
6.
Fasten the TouchLink panel to the mounting plate with
the lock screw (
6
).
steps 3 through 6
TOP
e
Back View
1
2
3
4
5
6
4
Figure 1.
Mounting the TLP Pro 725M with a Junction Box
figure 1