QGE 100 • Reference Information
55
55
Optimizing the Encoder Parameters
Using the QGE 100 Administrator software, you can set the parameters listed below (see
“
Using the QGE 100 Administrator Program
” in the “Software Configuration and
Control” section):
•
Bandwidth Limit
— If you are using a large number of QGE 100s or you have a slow
or busy network, you can reduce this value, which sets the maximum possible flow of
data being streamed onto the network. However, remember that this could cause the
refresh rate to be reduced, especially during periods of high source activity.
•
Refresh Rate (frames per second)
— If you have a source which does not require
a particularly high refresh rate but has a reasonably active content, you can set the
maximum possible refresh using this value. By keeping the bandwidth limit high, you
can keep both latency and the average bandwidth usage to a minimum.
