QGE 100 • Installation and Maintenance
9
Rear Panel Features
COM 1
OUT
IN
COM 2
DVI-I
DVI-I
12V DC IN
REG
1.5A MAX
PERIPH
PC
Refer all servicing to
qualified service personnel
1
2
3
4
5
7
8
9
6
Reserved for
Future Use
Figure 5.
QGE 100 Rear Panel
a
Power connector
— Connect the provided 12 VDC power supply to this female
3-pin mini DIN connector (see “
Connecting Power to the Unit
” for the connection
procedure and important cautions).
b
Ethernet port
— Connect a straight-through patch cable between this shielded
RJ-45 port and a router or switch that is connected to your local network (see
“
Connecting the QGE 100 to the Network
” on page 12 for pin assignments and
instructions for connecting to this port).
c
Periph (peripheral) mouse connector
— This loop-through connector enables
mouse control of the source computer to pass through the QGE 100. Plug the PS/2
mouse of the source computer into this female 6-pin mini DIN connector (indicated
on the rear panel by a mouse icon located between this connector and the PC mouse
connector). (See “
Connecting the Source Computer to the QGE 100
”on page 10
for PS/2 port pin assignments and instructions for connecting to this port).
d
PC mouse connector
— Connect one of the supplied PS/2 cables from this female
6-pin mini DIN connector to the PS/2 mouse port of the source computer (see
“
Connecting the Source Computer to the QGE 100
” for pin assignments and
instructions for connecting to this port).
e
COM 1 serial port
— This port is used for advanced diagnostics by Extron personnel.
It is not intended for use during normal operation.
f
DVI-I In monitor port
— Connect the appropriate provided cable (DVI or analog)
between this female DVI-I port and the monitor port of the source computer (see
“
Connecting the Source Computer to the QGE 100
,” below, for pin assignments
and instructions for connecting to the port).
g
DVI-I Out monitor port
— Connect the monitor of the source computer to this
female DVI-I loop-through connector (see “
Connecting the Source Computer to
the QGE 100
” for pin assignments and instructions for connecting to the port).
h
PC keyboard connector
— Connect one of the supplied PS/2 cables from this
female 6-pin mini DIN connector to the PS/2 keyboard port of the source computer
(see “
Connecting the Source Computer to the QGE 100
” for pin assignments and
instructions for connecting to this port).
i
Periph (peripheral) keyboard connector
— This loop-through connector enables
keyboard control of the source computer to pass through the QGE 100. Connect the
keyboard of the source computer to this female 6-pin mini DIN connector (indicated
on the rear panel by a keyboard icon located between this connector and the PC
keyboard connector). (See “
Connecting the Source Computer to the QGE 100
”
for pin assignments and instructions for connecting to this port.)
