Command and response table for SIS commands (continued)
PowerCage FOX SR HDMI Scaling Receiver • Remote Control
20
Command
ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Switch and signal status requests
Request Audio switch
status
E
STAT
}
EmbedAud
X1&]
Show the position of the Audio switch:
0
= off (embedded audio is muted) or
1
= on (unmute).
NOTE
:
The audio on the captive screw audio output always remains active regardless of the setting of this switch.
Check audio embed
E
5STAT
}
X1@]
Show if audio is embedded in the video stream:
0
= not detected or
1
= detected.
View link 1 (Tx-to-Rx) status
1S
X1*]
View link 2 (Rx-to-Tx) status
2S
X1*]
View input video status
3S
X1@]
View input audio status
4S
X1@]
View all signal status
5S
SigI
X1*
•
SigO
X1*
•
HdcpI
X1*
•
HdcpO
X1*]
Report the status of the HDMI input, HDMI output,
HDCP encoding on the input, and HDCP encoding on
the output.
View HDMI signal status
6S
SigI
X1@
•
SigO
X1@]
Report the status of the HDMI input and HDMI output.
View HDCP status
7S
HdcpI
X1@
•
HdcpO
X1@]
Report the status of the HDCP encoding on the input
and HDCP encoding on the output.
View temperature
20S
X1(
F
•
X1(
C
]
Show temperature in degrees Fahrenheit and Celsius.
View SFP module status
40S
X2)
•
X2!
•
X2@
•
X2#]
Information requests
Information request
I
1Lnk
X1*
•
2Lnk
X1*
•
Vid
X1@
•
Aud
X1@
•
X2$
•
SR
]
The unit responds with the current status (signal
detected) of optical link 1, optical link 2, the video
input, and the audio link; and the fiber optic
transmission mode (singlemode or multimode).
Show firmware version
Q
X2%]
Example:
Q
1.23
]
The factory-installed firmware version is 1.23 (sample
value only).
Request part number
N
70-904-
nn
]
See “
Part Numbers
” on page 29.
Resets
Reset image settings
E
ZI
}
Zpi
]
Reset (clear) all image adjustments.
System reset
E
ZXXX
}
Zpx
]
Reset all settings to factory defaults.
NOTE
:
X1@
= On and off status
0
= off
1
= on
X1&
= Switch position
0
= off (right)
1
= on (left)
X1*
= Link status
0
= light or signal input not detected
1
= light or signal detected
X1(
= Internal temperature
nnn
F
•
nn
C
X2)
= Vendor/manufacturer name
X2!
= Transmit output power in milliwatts
X2@
= Receive optical power in milliwatts
X2#
= SFP temperature
nn
C
X2$
= Transmission mode
SM
= singlemode
MM
= multimode
X2%
= Firmware version
v
.
vv
Summary of Contents for PowerCage FOX SR HDMI
Page 6: ......