PowerCage FOX SR HDMI Scaling Receiver • Installation and Operation
9
ATTENTION
:
•
Do not overtighten the HDMI connector mounting screw. The shield to which it
fastens is very thin and can easily be stripped.
•
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket (
d
).
5.
While holding the connector securely against the lacing bracket, use pliers or a similar
tool to tighten the tie wrap, then remove any excess length (
e
).
RS-232 connectors
The RS-232 Over Fiber port is for transmission of serial signals, such as projector control
signals, between the transmitter and receiver.
The Remote RS-232 port is for remote control of the receiver. The protocol for the Remote
RS-232 port is as follows:
Do not tin the wires!
Controlling
Device
Ground ( )
Receive (Rx)
Transmit (Tx)
Ground ( )
Receive (Rx)
Transmit (Tx)
Bidirectional
Function
Pin
Tx
Rx
Gnd
Transmit data
Receive data
Signal ground
RS-232
OVER FIBER
Tx Rx
1 2
REMOTE
RS-232
Tx Rx
ALARM
NOTE:
Cross the Tx and Rx lines once between
the source and the target.
Figure 7.
RS-232 Over Fiber Connector
NOTE
:
The length of exposed wires is important.
The ideal length is 3/16 inch (5 mm)
.
•
Longer bare wires can short together.
•
Shorter wires are not as secure in the connectors and could be pulled out.
•
9600 baud
•
no parity
•
8 data bits
•
1 stop bit
•
no flow control
Summary of Contents for PowerCage FOX SR HDMI
Page 6: ......