IPL Pro Series • Hardware Features and Installation
9
Front Panel Features
Examples of front panel features are
shown at right. The quantity
and location of ports and
corresponding front panel LEDs
differ among IPL models.
However, the functions of each
type of port and their LEDs are
identical for all models.
Most of the features
and LED indications are
described and shown in the
“Rear Panel Features and
Connections” section paired
with the descriptions of the
corresponding rear panel ports.
NOTE:
The control
processor must be set up
in order to function. See
the
Software-based
Configuration and
Control
section starting
on page 18 and the
Global Configurator Help
file for information about
Global Configurator,
which you must use to
set up the unit.
NOTE:
For reset mode
information, see
Resetting the Unit
on
page 15.
Reset Features
Reset button and LED
— Pressing this recessed button causes various IP functions
and Ethernet connection settings to be reset to the factory defaults. The green power LED
flashes depending on the selected reset mode (see
Resetting the Unit
and the reset
modes table on page 15 for details).
R
1000
LINK
ACT
COM
3
1
2
6
4
5
RTS
CTS
Tx
Rx
R
1000
LINK
ACT
IPL PRO S3
3
1
2
RTS
CTS
Tx
Rx
COM
COM
RTS
CTS
Tx
Rx
R
IPL PRO S1
IPL PRO S6
NOTE:
Numbers adjacent to LEDs
correspond to the like-numbered
rear panel ports.
COM (Serial)
LEDs
COM (Serial)
LEDs
Reset
Button
(recessed)
Reset
Button
(recessed)
Power
LED
Power
LED
Power
LED
LAN/
Network
LEDs
Figure 5.
IPL Pro Series Front Panels
IR Learning Receiver
In most cases, Extron has already produced a driver file for controlling the projector, display,
or source device you plan to use. If a device driver file is not available, you can create your
own using Extron IR Learner software, the remote control of the projector or display, and the
IR learning receiver sensor on the IPL, shown the figure above.
This receiver accepts infrared signals of from 30 kHz to 300 KHz. The IR remote control
must be pointed directly at the receiver for best results. The front panel diagram indicates
the best distances and angles at which to hold the remote control.
PRELIMINARY
