5
Cabling and Features
Attach cables using the following wiring diagrams as a guide. Full details are available in the
IPCP Pro Series User Guide
.
CAUTION:
ATTENTION :
•
Total length of the power cord including the small pigtail shall not be less than 1.5 m or more than 4.5 m.
•
La longueur totale du câble d’alimentation, cordon compris, ne doit pas être inférieure à 1,5 m ou supérieure à 4,5 m.
•
Always use the power cord provided with the unit.
•
Veillez à toujours utiliser le câble d’alimentation fourni avec l’unité.
•
Should you need to use a different power cord, consult Extron Electronics prior to using the cord.
•
Si vous devez utiliser un autre câble d’alimentation, contactez Extron Electronics avant d’utiliser ce câble.
Power Input — Internal
R
POWER
50-60Hz
50-60Hz
100-240V ~ 10A MAX
100-240V ~ 10A MAX
INPUT
OUTPUT
Power Input, Internal Power Supply
• Front panel LED ( ) blinks
during boot-up and remains lit
when the IPCP receives power.
• Connect to
100 to 240 VAC.
Rear Panel
Front Panel
6 inch (152 mm)
IEC Input Cable
To a 100 - 240 VAC
power source
(main power)
IEC Power Cord
Power Output — Switched AC Power Output
R
POWER
Circuit Breaker
(power output
overcurrent
protection)
Front
Panel
10
PR
E
S
S
T
O R
E
S
E
T
BREAKER
50-60Hz
50-60Hz
100-240V ~ 10A MAX
100-240V ~ 10A MAX
INPUT
OUTPUT
Rear
Panel
Switched 100-240 VAC, 10 A (Max.) Power Output
• Front panel Power LED appears:
• Lit green ( ) when power output is enabled (unit outputs power)
• Off ( ) when power output is disabled (power output is off)
• Lit red ( ) when a power output overcurrent condition is detected
(the circuit breaker has been tripped) and power output is disabled.
• Front panel
Power
button controls power output availablity.
NOTE:
The front panel power switch is not a safety disconnect
device. In case of emergency, disconnect AC power from the
power input (appliance inlet) of the connected equipment.
6 inch (152 mm)
IEC Output Cable
Power input port
on an AV device
(international)
or
Power input port
on an AV device
(USA)
IEC Power Cord
Edison Power Cord
NEMA 5-15R
Adapter
NOTES:
•
Within the United States of America use a power supply cord
with conductors that are a minimum diameter of 18 AWG.
•
For international installations, use a power supply cord with
conductors that are a minimum of 1.0 mm
2
.
•
Make sure that the device being controlled can support an
AC power cycle.
CAUTION:
Always
disconnect the
product from
the wall plug.
ATTENTION :
Veillez à toujours
déconnecter le
produit de la
prise murale.
ATTENTION:
•
When using the NEMA 5-15R receptacle
adapter, connect the equipment only to a
nominal 120 VAC electrical supply source.
•
Lorsque vous utilisez la prise de courant
NEMA 5-15R, veillez à ne connecter le
dispositif qu’à une source d’alimentation
nominale de 120 Vca.
