![Extron electronics FOX 500 Rx User Manual Download Page 14](http://html1.mh-extra.com/html/extron-electronics/fox-500-rx/fox-500-rx_user-manual_2456710014.webp)
FOX 500 Tx/Rx • Installation
Installation, cont’d
2-10
FOX 500 Tx/Rx • Installation
2-11
j
Audio Outputs connectors —
3.5 mm mini jack —
Plug a stereo mini plug into this connector.
5-pole captive screw connector —
This 5-pole, 3.5 mm captive
screw connector outputs the transmitted unamplified,
line level audio. Connect audio devices, such as an audio
amplifier or powered speakers.
See figure 2-8 to properly wire a captive screw output connector.
Use the supplied tie-wrap to strap the audio cable to the
extended tail of the connector.
Ring
Sleeve(s)
Tip
Tip
Ring
Sleeve(s)
Tip
Tip
Unbalanced Stereo Output
Balanced Stereo Output
NO GROUND HERE.
NO GROUND HERE.
L
R
Do not tin the wires!
Figure 2-8 — Captive screw connector wiring for
stereo audio output
C
Connect the sleeve to ground (Gnd). Connecting
the sleeve to a negative (-) terminal will damage the
audio output circuits.
N
The length of exposed wires is critical. The ideal length
is 3/16” (5 mm).
•
If the stripped section of wire is longer than 3/16”,
the exposed wires may touch, causing a short circuit
between them.
•
If the stripped section of wire is shorter than 3/16”,
wires can be easily pulled out even if tightly fastened
by the captive screws.
The volume level for the output can be set to either the
consumer level (-10 dBV) or the professional level (-4 dBu) via
the front panel or Ethernet or RS-232 control. See chapter 3,
"Operation", and chapter 4, "Remote Control", for details.
Receiver rear panel connections
All connectors except the Configuration port are on the rear
panel (figure 2-7).
FOX 500 Rx
AUDIO OUTPUTS
RGB OUTPUTS
R
G
B
S
H
V
L
R
RS-232
OVER FIBER
Tx Rx
NA
REMOTE
RS-232
ALARM
OPTICAL
2* 1
*
OPTIONAL FOR
RETURN DATA
LINK
LINK
Tx Rx
1 2
100-240V 0.3A
50/60 Hz
RGB
14
15
12
11
13
9
10
Figure 2-7 — FOX 500 Rx receiver’s connectors
i
RGB Outputs connectors
—
BNC connectors
— Connect
an RGBHV, RGBS, RGsB,
or RsGsBs video display
to these BNC connectors.
Connect the cables as shown
at right.
15-pin HD connector
—
Connect an analog
VGA - UXGA RGB video
display to this 15-pin HD
female connector.
N
You can set the
receiver to output
the desired video
format, RGBHV,
RGBS, or RGsB.
RGBHV is the
default. See
"Format submenu"
in "Output
Configuration menu" in chapter 3, "Operation".
R
RGBHV
G
B
V
RGBS
RGsB
B
S
R
G
V
R
G
B
H
H
H
S
S
V
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de