DTP2 T 201 D Transmitter • Remote Configuration and Control
16
Remote Configuration and
Control
This section describes remote operation of the DTP2 T 201 D by using Simple Instruction
Set (SIS) commands to control the DTP2 T 201 D transmitter. In addition this section
provides information about updating your device to the latest firmware.
The following topics are discussed:
•
•
•
Command and Response Table for SIS Commands
•
Downloading and Updating Firmware
Introduction to SIS
The DTP2 T 201 D transmitter accept SIS commands from a host device such as a
computer running the Extron DataViewer utility or other control system. The host device
can be connected to the Config port on the bottom panel (see
SIS commands consist of strings (one or more characters per command field). Upper and
lower case characters can be used interchangeably. Commands do not require any special
characters to begin or end the command string. Each response from the DTP2 T 201 D
transmitter ends with a carriage return and a line feed (CR/LF =
]
), which signals the end
of the response character string.
When the transmitter is first switched on, it sends the message:
(c) Copyright 20
xx
,
Extron
Electronics
DTP2 T 201 D,
V
x.xx
60‑
xxxx‑xx
]
•
V
x.xx
is the firmware version number.
•
60‑
xxxx‑xx
is the part number of the device.
Error Messages
E10
— Invalid command
E13
— Invalid parameter
Summary of Contents for DTP2 T 201 D
Page 2: ...Safety Instructions ...
Page 6: ......