1 Attach the flat metal indoor bracket to the main bracket. Keep the bracket to the center of the main
bracket, push and rotate it.
Figure 12: Attaching the optional Flat Metal Indoor Adaptor to the main mounting
bracket
2 Hold the AP to the surface to which it needs to be attached and use the optional bracket’s end holes
as a template to mark the attachment holes.
3 Drill two holes on the wall where you want to mount the AP.
4 Connect the LAN/Ethernet cable to the back of the AP.
5 Hold the AP, insert and tighten the 2 screws until you lock it into place.
Note
The “E” logo must be in the right orientation before tightening the screws.
Mounting to a wall using the Philips Pan-head screws
You can mount the AP3915e access point directly onto a dry/solid wall using the Philips Pan-Head
screws. This is an optional installation method and not the preferred mode of installation.
Warning
This option can be used to mount only on a wall where there is gravity to hold the screws and
AP in place.
Caution
If the AP is mounted on a ceiling, it will fall off the screw heads.
1 Drill two holes 104 mm (4.100”) apart from each other on the wall where you want to mount the AP.
Installation Process
ExtremeWireless™ AP3915e FCC/ROW Install Guide
22
