33
48.
Assemble one end of the linkage by inserting the pull-pull cable
into a crimp, through the hole in the brass pull-pull fitting and back
through the crimp. Loop the cable back through the crimp a
second time and crimp with side cutters.
49.
Insert the bare end of the cable into the slot in the rear of the
fuselage and feed it forward through the hole in the former that is
positioned just in from of the slot. Pull the cable forward into the
canopy area and make up the same type of linkage as you did
previously. Electronically center your servo. Secure the linkage at
both ends with a 3mm bolt and nylon insert lock nut. Repeat for
the other side. Again, you will want to use a 4 inch arm for the
pull-pull system and
cross the cables
.
