16
24.
Locate a 2mm ball link from the hardware bag. Remove the
covering from the hole on the bottom of the rudder.
25.
Scuff the shaft of the ball link with coarse sandpaper. Mix up a
small amount of 5 minute epoxy and apply it to the ball link and
the hole in the bottom of the rudder. Push the ball link into the
hole as shown in the picture. Use a little excess epoxy to form a
fillet around the bottom of the ball link. Make sure the hole in the
brass ball is aligned front to rear to accept the tailwheel tiller arm.
Go ahead and glue the hinges into the rudder at this time using the
procedure outlined previously.
