Extreme Flight 110" YAK-54 V2, Assembly Manual

Page: 19 / 45

Figure 12
NOTE : the washers used on the axles have a slightly larger hole than the washers
for the MLG, please differentiate this before proceeding.
Now slide the spat onto the axle and over the hex head of the axle, then install the
3mm bolt/washer into the blind nut and tighten, use BTL.
If the spat does not have a predrilled hole you will need approximately a 5/8” hole
to fit over the hex head of the axle. I hold the spat onto the tire to approximate
19