Exterior NVR21 Series, User Manual

Page: 128 / 262

116

You need to set alarm record mode as Schedule in Record interface (Main
Menu->Advanced->Record). Please note the manual record has the highest priority.
System record all the time no matter there is an alarm or not if you select Manual mode.

Now you can go to the Schedule interface (Main Menu->Setting->Schedule) to set the
record type, corresponding channel number, week and date. You can select the record
type:Regular/MD/Alarm/MD&Alarm. Please note, you can not select the MD&Alarm and
MD(or Alarm) at the same time.

Now you can go to the Encode interface to select the alarm record and set the encode
parameter (Main Menu->Setting->Encode).

Finally, you can set the alarm input as the local alarm and then select the record channel.
The select channel begins alarm record when an alarm occurred. Please note system
begins the alarm record instead of the MD record if the local alarm and MD event
occurred at the same time.

Tour: Here you can enable tour function when an alarm occurs. System supports 1/8-window
tour. Please go to chapter5.4.4.2 Display for tour interval setup. Please note the tour setup
here has higher priority than the tour setup you set in the Display interface. Once there two
tours are both enabled, system can enable the alarm tour as you set here when an alarm
occurred. If there is no alarm, system implements the tour setup in the Display interface.

Snapshot: You can enable this function to snapshoot image when an alarm occurs.

Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm occurs.
Figure 5-58