Exterior NVR21 Series, User Manual

Page: 123 / 262

111

Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if you enabled current function.

Send email: System can send out email to alert you when an alarm occurs.

Record channel: Select the channel to activate recording function once an alarm occurred.
Please make sure you have set MD record in encode interface(Main
Menu->Setting->Schedule) and schedule record in manual record interface(Main
Menu->Advanced->Manual Record)

PTZ activation: Here you can set PTZ movement when an alarm occurs. System can go to a
preset, when there is an alarm. Click
“
select
”
button, you can see an interface is shown as in
Figure 5-52.

Record Delay: System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.

Tour: Here you can enable tour function when an alarm occurs. System one-window tour.
Please go to chapter 5.3.9 Display for tour interval setup.

Snapshot: You can enable this function to snapshoot image when motion detect alarm
occurs.
Please highlight icon to select the corresponding function. After all the setups please click
save button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in
each channel may not be the same.
In Figure 5-51, you can left click mouse and then drag it to set a region for motion detection. Click
Fn to switch between arm/withdraw motion detection. After setting, click enter button to exit.
Figure 5-50