Explorer Group 2005 AVANTE, Owner'S Handbook Manual

Page: 33 / 133

periodically to ensure they are working. If
the battery in the sensor is low the tone
will change to a low frequency tone as a
warning. Note that a PIR will not transmit
within 20 seconds of the last trigger to
conserve battery power. Ensure that you
wait for at least this time before testing the
sensor again.
Arm the alarm with a long push on the
arm/disarm button. "On" indication will be
followed by the test mode tone.
LED will illuminate permanently.
Settling time of 5 seconds before
responding to triggers.
Tone of response will also indicate battery
low.
It is also possible to enter test mode and
isolate the "at home" sensors.
Arm the alarm with a long push followed
by a second short push.
The "on" tone will be followed by the test
tone and then the "at home" tone.
SWITCH OFF CHIRPS PERMANENTLY.
Insert touch-key for ten seconds.
The LED turns on continuously for the first
5 seconds and rapid flashes for the next 5
seconds after which one audible beep is
heard followed by a double beep, this
single and double beep sequence is
repeated.
If you want audible indication, remove
touch-key after a single beep is heard. If
you don't want audible indication, remove
touch-key after a double beep is heard.
PROGRAMMING
Programming any additional sensors,
transmitters or touchkeys can only be
done with an existing touchkey. The
quantity of devices that can be stored is
as follows.
Remote control Transmitters 4
Touchkeys 4
Sensors (PIR and leg sensors) 12
An attempt to program an accessory in
excess of the above number will result in
overwriting the first accessories code.
Note that a PIR will not transmit within 20
seconds of the last trigger to conserve
battery power.
Ensure that you wait for at least this time if
you passed the PIR to enter program
mode.
LEARNING A NEW TOUCH-KEY OR
TRANSMITTER.
With the alarm disarmed insert a valid
touch-key into the receptacle.
After 5 seconds the LED will flash rapidly
indicating that you are in learn mode -
remove the touch-key.
Momentarily insert the new touch-key or
transmit with the new transmitter. Once
the new code is recognised by the alarm
a short beep will sound.
RECEPTACLE AND TOUCH-KEY (two supplied)
RECEPTACLE
STATUS LED
TOUCH-KEY
32
Security